Starline Unprimed Rifle Brass 6.5 Grendel 100 Count

Starline Unprimed Rifle Brass 6.5 Grendel 100 Count
by Starline Brass  is proud to offer Starline Unprimed Rifle Brass 6.5 Grendel in a convenient 100 Count. Starline cartridge cases are well known for their exceptional quality and construction. Using detailed build procedures for the 6.5 Grendel unprimed brass ensures higher concentricity in each case that will ease bullet seating and round seating in your chamber. Our 6.5 Grendel Brass cases also ensure very tight tolerances in their case wall thickness to produce the most accurate ammunition possible. Starline’s unique case creation allows the user more reloads and guarantees virtually identical cases from lot to lot.
Where to buy Starline Unprimed Rifle Brass 6.5 Grendel 100 Count

The 6.5 Grendel unprimed brass is very consistent and will make reloading a simple and easy task. No more hours of trimming and sizing, thanks to the steps Starline takes to ensure the rifle brass is correct when it leaves the factory.

Starline Brass prides itself on producing the highest quality brass case available. Their brass is comprised of 70% copper and 30% zinc and is vertically drawn during the manufacturing process which results in more uniform wall thickness. Cases are annealed between each draw to ensure consistent metallurgy in all lots. Each brass case is hand inspected to guarantee the highest quality possible. Starline Unprimed Rifle Brass 6.5 Grendel 100 Count

Starline Brass is located in Sedalia, MO and has been in business for over 30 years. Trust Starline for your next reloads, you won’t be disappointed. New, unprimed brass. This is not loaded ammunition. Bulk brass should be full-length sized, trimmed and chamfered before loading.

Brass Preparation: With bulk rifle brass you may sometimes notice a few case mouths are “out of round” or slightly dented below the shoulder.  These imperfections occur in the final tumbling wash operation after the case mouth has been annealed.  Brass manufacturers are aware of the case cosmetics and have worked to mitigate it, but due to equipment design, denting may still occur.  Minor dents are normally removed in the first firing and will not affect case life or performance.  On non-plated brass, you may also notice all the anneal stain might not be polished off, which may give the case neck a pinkish color.  With some smaller caliber cases you may notice the case mouths to be slightly belled.

With all new rifle brass, you should first straighten out the case and case mouth, then chamfer and debur the case mouth inside and out.  To straighten the case mouth, run the case part way into the sizer die and let the expander ball straighten the brass.  To prevent the case neck from stretching, be sure to lubricate the case neck inside the case mouth.

If you are using Nickel plated brass, special care must be taken to lubricate the cases prior to sizing them.  Nickel plating is harder than brass and the cases require more effort in sizing.  In the event a case becomes stuck, purchase a stuck case remover; don’t use pliers, screwdrivers or other common household tools which could damage your sizing die.

Specifications and Features:

• Tight tolerances for concentricity
• Controlled wall thickness
• Correct sizes lot to lot
• Small Rifle Primer